How to Dye Human Hair Full Lace and Lace Front Wigs

How to Dye Human Hair Full Lace and Lace Front Wigs

Most women spend lots of money buying human hair wigs than synthetic wigs,why? they can do anything to human hair full lace wigs or lace front wigs just like their own hair. but not all the same,can human hair wigs be dyed?here is instruction of how to dye human hair wigs:

dye hair

Products Needed:
Preparing the Dye
The first thing you will need is to prepare the dye you like. The next thing you need is a wig stand; otherwise you will not be able to see the wig at all times. A nonmetal bowl is needed to mix the dye; metal bowls can change the color of the dye. Nylon brush is needed to apply the dye to every strand of hair on the wig evenly. Rubber gloves are needed to protect your hands so they will not be stained by the dye. You will need a wide tooth comb, so that you can comb the wig to make sure all the strands are coated with dye.

Preparing your full lace wig or lace front wig:

You need to wash the lace wig at least 48 hours prior to you dying it so that you can get the build up from chemicals out of the wig. You need the next 24 hours to allow the wig to completely air dry. The wig needs to be clean and dry before you can apply the dye to the hair. After the 48 hours has passed, you need to put the wig onto the wig stand and section it into four sections to allow for easy applying of the color, evenly onto all strands of hair.

Place the plastic gloves on your hands to protect your hand from dye. Place a towel below your nonmetal bowl so that nothing is damaged. Pour the hair dye into the bowl followed by an equal amount of developer. You want an equal amount of each so that the dye is perfectly mixed and there is the necessary balance needed to produce the color you desire.

Applying the Dye
Start at one of the two sections of the four sections you parted, you have to think of the crown of the wig as your roots. Start at the "roots" with the nylon brush and move all the way to the ends of the first section, repeat this for the remaining three sections. Take the wide tooth comb and move from front to back combing the entire wig to make sure every strand is covered in dye. Let the dye then stand on the wig for 20 to 25 minutes, to ensure the wig absorbs the color. After the time has passed, you will need to rinse the dye out the wig with cool water, working from the bottom to the top. Then shampoo the wig and rinse; follow with a light based conditioner that is rinse out. You do not want to use a leave in as it will weigh the wig down. After you remove the conditioner, you can wear the wig after it air dried.
Now you get a new looking,it is amazing,right?

Add new comment
Name *
Comment *
Verification Code  *